Forced Performance
FP6875 Race Turbocharger
FP6875 Race Turbocharger
Couldn't load pickup availability
- Flow rating - 100lb/min
- CW Measurements - 68MM Inducer
- TW Measurements - 75MM Exducer
- Compressor Housing - 4" Inlet and 3" Outlet
- Turbine Housing - T4 Open .81 or .96 A/R
- Turbine Outlet Flange - 3 5/8" V-Band discharge
- CHRA - FP Journal Bearing
The FP6875 Race Turbocharger from Forced Performance is a great turbo for stock to mildly built LS motors, inline six cars, and budget 68mm inducer class 4cyl cars.
With its billet compressor wheel and 75mm turbine exducer, you can expect to see between 500 and 750 horsepower from a single turbo application, or up to 1500 in a twin setup. On a well sorted I4/I6 car you can expect close to 800-1000hp.
We offer this in three different T4 turbine housings, a .81 A/R and a .96 A/R open. We recommend the .81 for smaller motors or twin setups, while the .96 responds very well on a larger motor such as a 5.3 or such applications that use a larger cam than stock.
Additionally these are offered with an integrated TiAL F38 flange already ported and ready for action! We offer the F38 setup in either a .81 or .96 A/R.
*wastegate shown for fitment purposes only*
EPA WARNING: This is a RACE ONLY product manufactured and sold for installation on vehicles to beused solely for competition purposes, which, once installed, may never be used, or registered orlicensed for use upon a public road or highway. Higher Standards automotive performance LLC is notresponsible for the sale or misuse of products sold by us intended for competition use only. If you installthis part on your vehicle and use that vehicle on a public road or highway, you will be considered inviolation of the Clean Air Act and personally subject to a civil penalty of $4,454. Clean Air Act Title II Section 203 Code 7522(a)(3)(A) for any person to remove or render inoperative any device or element of design installed on or in amotor vehicle or motor vehicle engine in compliance with regulations under this subchapter prior to itssale and delivery to the ultimate purchaser, or for any person knowingly to remove or renderinoperative any such device or element of design after such sale and delivery to the ultimate purchaser;or(B) for any person to manufacture or sell, or offer to sell, or install, any part or component intended foruse with, or as part of, any motor vehicle or motor vehicle engine, where a principal effect of the part orcomponent is to bypass, defeat, or render inoperative any device or element of design installed on or ina motor vehicle or motor vehicle engine in compliance with regulations under this subchapter, andwhere the person knows or should know that such part or component is being offered for sale orinstalled for such use or put to such use; or .
Share
