Forced Performance
FP Black Ball Bearing for DSM
FP Black Ball Bearing for DSM
Couldn't load pickup availability
- Compressor wheel - 82HTZ
- Flow rating - 71LB per minute
- CW Measurements - 59.1MM Inducer / 82MM Exducer
- TW Measurements - 67.3MM Inducer / 58.8MM Exducer
- Compressor Housing - 84MM Flow Advancement Port Cover
- Turbine Housing - FP 10CM
- CHRA - XR Ball Bearing
- Oil Line - Not Included
The FP Black Ball Bearing Turbocharger for DSM features our 82MM HTZ wheel rated at 71LB a minute. This turbo uses our Xona Rotor ball bearing center section for maximum performance and reliability. We also developed our own 10cm housing for maximum flow while retaining bolt on fitment. Due to the flow of this turbo and turbine housing, this will only be offered with an external wastegate off O2 setup.
Attention: All Forced Performance turbochargers are built to order to your exact specifications and should not be considered on the shelf ready to ship unless specifically noted on the work order. Build times vary by model of turbo and options of said turbocharger, therefore we cannot guarantee a delivery date or ETA.
EPA WARNING: This is a RACE ONLY product manufactured and sold for installation on vehicles to beused solely for competition purposes, which, once installed, may never be used, or registered orlicensed for use upon a public road or highway. Higher Standards automotive performance LLC is notresponsible for the sale or misuse of products sold by us intended for competition use only. If you installthis part on your vehicle and use that vehicle on a public road or highway, you will be considered inviolation of the Clean Air Act and personally subject to a civil penalty of $4,454. Clean Air Act Title II Section 203 Code 7522(a)(3)(A) for any person to remove or render inoperative any device or element of design installed on or in amotor vehicle or motor vehicle engine in compliance with regulations under this subchapter prior to itssale and delivery to the ultimate purchaser, or for any person knowingly to remove or renderinoperative any such device or element of design after such sale and delivery to the ultimate purchaser;or(B) for any person to manufacture or sell, or offer to sell, or install, any part or component intended foruse with, or as part of, any motor vehicle or motor vehicle engine, where a principal effect of the part orcomponent is to bypass, defeat, or render inoperative any device or element of design installed on or ina motor vehicle or motor vehicle engine in compliance with regulations under this subchapter, andwhere the person knows or should know that such part or component is being offered for sale orinstalled for such use or put to such use; or .
Share
