Forced Performance
FP 68HTA for DSM
FP 68HTA for DSM
Couldn't load pickup availability
DSM 68HTA V2
- Compressor wheel - 68HTA
- Flow rating - 51LB per minute
- CW Measurements - 51.2MM Inducer / 68MM Exducer
- TW Measurements - 60.8MM Inducer / 54MM Exducer
- Compressor Housing - 16G TD05H (56mm)
- Turbine Housing - FP 8CM
- CHRA - FP Journal Bearing
- Oil Line - Not Included
The FP 68HTA™ Turbocharger for DSM flanged vehicles out flows both the E3 16G and 18G wheels and allows for higher PR operation without increased compressor outlet temperatures like the existing 16G and 18G wheels. Mass flow is increased to a whopping 51lb/min which is several lb/min greater than either the E3 16G or the 18G wheels are capable. To maximize its power potential this turbo comes standard with a 8CM turbine housing.
Attention: All Forced Performance turbochargers are built to order to your exact specifications and should not be considered on the shelf ready to ship unless specifically noted on the work order. Build times vary by model of turbo and options of said turbocharger, therefore we cannot guarantee a delivery date or ETA.
EPA WARNING: This is a RACE ONLY product manufactured and sold for installation on vehicles to beused solely for competition purposes, which, once installed, may never be used, or registered orlicensed for use upon a public road or highway. Higher Standards automotive performance LLC is notresponsible for the sale or misuse of products sold by us intended for competition use only. If you installthis part on your vehicle and use that vehicle on a public road or highway, you will be considered inviolation of the Clean Air Act and personally subject to a civil penalty of $4,454. Clean Air Act Title II Section 203 Code 7522(a)(3)(A) for any person to remove or render inoperative any device or element of design installed on or in amotor vehicle or motor vehicle engine in compliance with regulations under this subchapter prior to itssale and delivery to the ultimate purchaser, or for any person knowingly to remove or renderinoperative any such device or element of design after such sale and delivery to the ultimate purchaser;or(B) for any person to manufacture or sell, or offer to sell, or install, any part or component intended foruse with, or as part of, any motor vehicle or motor vehicle engine, where a principal effect of the part orcomponent is to bypass, defeat, or render inoperative any device or element of design installed on or ina motor vehicle or motor vehicle engine in compliance with regulations under this subchapter, andwhere the person knows or should know that such part or component is being offered for sale orinstalled for such use or put to such use; or .
Share
